12
Heat/Cool Mode Press the Mode button to switch from one mode to another.
( Available only in heat and cool machine. )
Permanent Display
The LED screen will always display Water temperature in swimming pool
Common setting
1． Heat/Cool Mode
Press the Mode button to switch from one mode to another.
（
Available only in heat and cool machine.
）
2． Required pool water temperature
It can be adjusted both when the machine is on or off.
A. Press UP-ALLOW key or DOWN-ALLOW key to set to your required pool
water temperature.
B. The numbers in the LED screen will flash during your operation.
C. After five seconds, it will stop flashing and be saved, the LED screen will return
to the permanent display. (it shows temperature of water)
D. When you want to check the temperature, press UP-ALLOW key or
DOWN-ALLOW key to see the current setting.
IV Maintenance
A． In winter season when you don’t swim:
1. Cut off power supply to prevent any machine damage
“Cut off” power supply of the heater before
cleaning, examination and repairing
To Next Page
Loading...