EasyManua.ls Logo

Rapid RH25L - Trial After First Installation

Rapid RH25L
73 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7
avoid any damage to this unit.
Never place heat pump near sprinkler systems, evaporation of acid or alkaline gas. If you live in an
oceanfront area, the heat pump should be placed out of direct spray of sand and salt, since this will also
clog, damage, and corrode the unit. You may consider protecting your heat pump by planting shrubbery
or a privacy fence between the unit and the prevailing beachfront wind.
4 When the machine is running, there will be condensation water discharged from the
bottom. Make sure there is enough space for water drainage.
Water pipe connection
- The water flow through this machine needs to be driven by an appended water pump
(Prepared by the user). The recommended pump specification-flux is shown on the
product specification and Max. lift 10m;
- Pipe length between heat pump and swimming pool should not be longer than 10m.
TIPS: HEAT PUMPS GENERATE WATER CONDENSATION DURING NORMAL
OPERATION. THIS SHOULD NOT BE MISTAKEN FOR A LEAK IN THE UNIT.
Noted: The drawing is just for demonstration, and layout of the pipes for reference.

Table of Contents