Raritan PM Series User Manual

Chapter 1: Installation and Initial Configuration
2
Hardware Installation
BCM2 supports two hardware options. Select your hardware version for
installation instructions:
• BCM2 9600 series (see " BCM2 Series Hardware Installation " on
page 2)
• PM Series: PMC-1000, PMC-1001, PMM-1000, PMB-1960,
PMMC-1000 (see " PM Series Hardware Installation: PMC-1000,
PMC-1001, PMM-1000, PMB-1960, PMMC-1000 " on page 13)
BCM2 Series Hardware Installation
Safety Information
DANGER!
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
 Follow safe electrical work practices. See NFPA 70E in the USA, or
applicable local codes.
 This equipment must only be installed and serviced by qualified
electrical personnel.
 Read, understand and follow the instructions before installing this
product.
 Turn off all power supplying equipment before working on or inside
the equipment.
 Any covers that may be displaced during the installation must be
reinstalled before powering the unit.
 Use a properly rated voltage sensing device to confirm power is off.
 DO NOT DEPEND ON THIS PRODUCT FOR VOLTAGE INDICATION
 Failure to follow these instructions will result in death or serious
injury.
NOTICE
 This product is not intended for life or safety applications.
 Do not install this product in hazardous or classified locations.
 The installer is responsible for conformance to all applicable codes.
 Mount this product inside a suitable fire and electrical enclosure.
CAUTION

Raritan PM Series Specifications

General

Brand	Raritan
Model	PM Series
Category	Measuring Instruments
Language	English