Rascal AutoGo Owner’s Manual
EMC Part: 19286400 Rev.01 03/09/07
10
Charge the batteries as follows:
1. For your convenience, you can detach the Battery Pack from the Rascal AutoGo and move it to a 3-Prong Grounded
Electrical Receptacle. If you choose, you can also park the Rascal AutoGo near a 3-Prong Grounded Electrical
Receptacle without removing the Battery Pack.
WARNING!
Use of a non-grounded receptacle could result in an electrical shock.
2. Use the separate Charger Power Cord, included in kit with this Owners Manual, and plug it into the 3-Prong
Grounded Electrical Receptacle on the rear of the Battery Pack. Your Charger Power Cord is equipped with either a
110V or 220V plug. If you wish to purchase either cord for travel to different countries, contact the Customer
Service Department to purchase a cord for 220V (UK), 220V (Europe), 100V (Japan) locales.
3. Check that the LED on the rear of the Battery Pack is lit. This indicates that the Charger is recharging the batteries.
4. Normal charging time is generally 6-8 hours for fully discharged batteries.
5. Disconnect the Charger Power cord from the Battery Pack and wall outlet. We recommend that you keep the cord
in the storage pouch underneath the seat so it is readily available.
Note: Do not operate vehicle while charging.
To Next Page
Loading...
