Rath SmartRescue 10 User Manual

Programming the Phone(s)
Step 10
1.Optionsforprogrammingthephone(s)
Option 1
Call emergency numbers o󰀨site, without stopping at the SmartRescue
a. Press Enter to get into program mode
b. Press 1, Enter, (Emergency Number), Stop
c. If using two emergency numbers: Press 2, Enter, (Emergency Number), Stop
d. Repeat for up to 5 total emergency numbers
e. To exit programm mode: Press and hold Stop for 2-3 seconds until warble sound
Programming the Phone(s)
Option 2
Call SmartRescue rst, if no answer call emergency numbers o󰀨site
a. Press Enter to get into program mode
b. Press 1, Enter, (Emergency Number), Stop
c. Press 2, Enter, (same Emergency Numberasenteredinb.),Stop
d. To exit programm mode: Press and hold Stop for 2-3 seconds until warble sound
2. Program the location message
Note: This is always done unless your Call Center requrest it not to be
a. Press Enter to get into program mode
b. To turn on message, press 1, 3, Enter, 2
i. For no message, press 1, 3, Emter. 0
c. Press 6, Record, (waitforbeep,speakyourmessage),Stop
d. To program frequency of message, press 1, 3, Enter, ___
i. 1 = plays message once
  ii.2=playsmessagetwice(thisisstandardconguration)
iii. 3 = plays message until the called party presses * on their phone
e. To exit program mode, press and hold Stop for 2-3 seconds until warble sound
*Note: Elevator Industry: REQUIRED to have the ability to call into each elevator from
outside the building. For instructions on how to put each phone into Consolidator Mode see
page 13.
Page 8

Rath SmartRescue 10 Specifications

General

Brand	Rath
Model	SmartRescue 10
Category	Emergency Phone
Language	English