Ratio iX3M - CCR Settings for RATIO Ix3 M Tech+ & Ix3 M Reb

33
CCR Settings for RATIO iX3M Tech+ & iX3M
Reb
To navigate the menu follow the instructions in the picture on the left.
CCR MODE:
ON= CCR enabled in scuba mode.
OFF= Deactivated.
SETPOINT LOW: Range 0.40 a 1.60 (Step 0.05). It is the starting setpoint.
SETPOINT MED: Range 0.40 a 1.60 (Step 0.05)
SETPOINT HIGH: Range 0.40 a 1.60 (Step 0.05)
Attention: Enable the Rebreather mode (CCR) only for dives with rebreather.
The CCR mode is not suitable for dives in open circuit!
Attention: Diving with Rebreather requires a specifi c training. Diving with
Rebreather without a suitable training or without the due caution can cause
injuries or death.
Refer to your Rebreather instructor to get instructions on how to set the SET POINT
Do you know what?: You can keep pressed the buttons C or D to change the iX3M data more rapidly.
A
B
To reach this menu from the main
screen press in sequence:
CCR SETTINGS
CCR MODE:
SETPOINT LOW:
SETPOINT MED:
SETPOINT HIGH
B
A C D
EXIT
NEXT
ENTRY
+
_
OFF
0.70
1.00
1.40
D
D
For iX3M Tech+ iX3M Reb