55
If the previously used radio channel is busy, the column automatically searches for a new radio channel to use. The display shows
the following message:
F R E E C H A N N E L
> > 3 S E L E C T ? < <
The operator must ensure that all columns have the same radio channel indicated by the
system (3 in our example) before conrming the selection with the black “ENTER” key on each column. If this does not happen, or
the operator wants to operate the power lift on a different channel than the one specied by the system, the operator must choose
a new channel by using the RED and GREEN keys on all columns that form the power lift and conrm the selection by pressing
the black”ENTER” key.
Display language selection
Once you have selected the work conguration you may select
the display language.
To change the language, from inside the USER MENU scroll down till
you nd Menu - 6 LANGUAGE.
5 R A D I O I n f o
>> 6 L A N G U A G E <<
Press the black “ENTER” button .
Scroll down until you nd your language (for example English)
and conrm your choice by pressing the black “ENTER” button
.
Using the power lift
WARNING: if you press a button before 2 seconds have passed
since the previous command was released, the selected
command will not be activated and the display will show:
H e i g h t 1 1 1 1 mm
C M D N O T P O S S I B L E
Ascent, active on all activated columns
H e i g h t 0 0 0 0 mm
UP A L L
H e i g h t 0 0 0 0 mm
UP GROUP
Descent, active on all activated columns
H e i g h t 1 1 1 1 mm
DOWN A L L
H e i g h t 1 1 1 1 mm
DOWN GROUP
Slow descent, active on all activated columns
H e i g h t 1 1 1 1 mm
SLOW DOWN A L L
H e i g h t 1 1 1 1 mm
SLOW DOWN GROUP
Single (double button), active only by “ ALL”
H e i g h t 0 0 0 0 mm
U P S I N G L E
If the truck is misaligned by over 40 mm
when the command is released, the display shows:
H e i g h t 1 1 1 1 mm
A L I G N M E N T F A I L
if an ascent or descent button is pressed
the display shows:
H e i g h t 1 1 1 1 mm
C M D N O T P O S S I B L E
7
M E N U USER
I T A L I A N O
>> ENGLISH <<
0526-M002-3