57
> > G R O U P M O D E < <
N O T P O S S I B L E
2) repeat the operations on all the columns that you intend to enter in the group.
After selecting the GROUP function, the following shall appear on the selected columns:
H e i g h t 1 1 1 1 mm
G R O U P
and on the columns excluded from the group:
H e i g h t 1 1 1 1 mm
E S C L U D E D C O L U M N
The Ascent, Descent and Slow Descent commands are only available for the columns in the group; all other columns remain
stationary. The single and parking commands are not available (“CMD NOT POSSIBLE”).
This mode allows operations with regard to other columns that make up the power lift only on columns belonging to a group.
These offsets are maintained during any subsequent operations in ALL mode.
D) From “GROUP” mode to “ALL” mode
1) the display shows:
H e i g h t 1 1 1 1 mm
G R O U P
Press the black “ENTER” key
the following is displayed:
1 A l l M o d e
> >
2 G r o u p M o d e
< <
move up with the yellow key , to
> > 1 A l l M o d e < <
2 G r o u p M o d e
conrm with the black “ENTER” key
the following is displayed:
> > A L L R E Q ? < <
E x i t
conrm with the black “ENTER” key
Selecting the ALL mode, the following is displayed:
> > A L L M O D E < <
S E L E C T E D . .
2) Repeat the operations on all the columns that are entered in GROUP mode.
- ATTENTION: If the columns in “GROUP” mode are turned off and then turned on again, they will be set to “ALL” mode.
7
0526-M002-3
To Next Page
Loading...
