Raven GO Duplex - Error Conditions; Error Indicators and Solutions

Error Conditions
If there is error during scanning, the LED light will be flashing in red color. Refer to the
following table to clear the error conditions.
Error & LED Indicator
Cause
Solution
Paper Jam
4 Continuous Blinks
Document has become
stuck in the feeder.
Remove paper and try
again. The Red LED light
does not stop blinking
unless the paper is
removed.
Cover Open
6 Continuous Blinks
Feeder cover is open.
Close cover and then try
again. The Red LED will not
stop blinking unless the
cover has been closed.
Calibration Fails
8 Continuous Blinks
The calibration attempt
has failed.
Recalibrate the
scanner.(See the Calibrate
Scanner” Section)
23 support@raven.com | 1-800-713-9009 | raven.com/support