Connect The Scanner
2.1 Connect one end of the power cable to the power receptacle of the scanner.
Connect the other end to an appropriate power outlet.
● ATTENTION: Please make sure the scanner is turned OFF before you plug or
unplug the scanner power adapter.
2.2 (Optional) To use a wired internet connection, connect one end of your Ethernet LAN
cable to an available port of your Ethernet Hub (router/modem). Connect the other end
to the port marked at the back of the product.
2.3 Switch on the scanner power from the rear of the scanner.
14
To Next Page
Loading...
Need help?
General
