Raven Scanner Pro - Setting Up Your Scanner; Install and Connect to Power


Setting Up Your Scanner

Install the Scanner




1.1 Hold the ADF Paper Tray and insert 1.2 Pull out the extension to the length 
two pins to the holes on the top of the of the document. Pull the Output Tray
scanner as shown. and raise the paper stopper to prevent
the paper from falling.


Connect to Power


2.1 (Optional) Connect one end of your 2.2 Connect one end of the power
cable
Ethernet LAN cable to an available port of to the power receptacle of the
product.
your Ethernet Hub, connect the other end to Connect the other end to an
port marked at the back of the product. appropriate power outlet.


11