3
4. Locate the factory power and ground wire cluster under the instrument panel.
The factory wire cluster is spliced into power and ground wires which lead to the
accessory port or cigarette lighter in the vehicle cabin.
5. Trace wires to help identify the power (red) and ground (white) wires used to
power the Viper Pro field computer.
6. Using the supplied wire cutter/stripper (P/N 321-0000-393), cut the power and
ground leads powering the field computer approximately 2 in [5 cm] from the
factory splice.
Note: A crimp connector will be installed on the red (power) wire still connected to
the factory splice later in this process.
7. Locate the knockout below the instrument panel and route the leads cut from
the factory splice through an open port.
8. Crimp the supplied ring terminals (P/N 405-0200-053) onto each of the lead
wires.
CAUTION
Damage to electrical equipment or electrical
shock may occur when cutting power and
ground wires. Disconnect the vehicle battery,
use insulated tools or wear rubber gloves as
appropriate.
To Next Page
Loading...
