To Next Page
S
sandovalcandiceAug 20, 2025
Why can't I enable the RS1 system for guidance and steering on my Raven Farm Equipment?
- KKevin CastanedaAug 20, 2025
The RS1 system cannot be enabled for guidance and steering operation until active DTCs are resolved.
Why can't I enable the RS1 system for guidance and steering on my Raven Farm Equipment?
The RS1 system cannot be enabled for guidance and steering operation until active DTCs are resolved.
How to enable SC1/TC1 system on Raven Farm Equipment?
The master switch must be toggled to 'field mode' to enable the SC1/TC1 system on your Raven Farm Equipment.
Why can't I enable the RS1 system for guidance and steering on my Raven RS1/HDU?
The RS1 system cannot be enabled for guidance and steering because there are active diagnostic trouble codes (DTCs) present. You need to fix the active DTCs to enable the system.
What to do if the RS1 system cannot be engaged in Raven RS1/HDU Control Systems?
The RS1 system cannot be engaged because there are active diagnostic and troubleshooting codes present. You should fix these active codes to resolve the issue.
Why is my Raven Control Systems RS1 performance degraded?
The performance quality of the RS1 system may be degraded because there are active diagnostic and troubleshooting codes present. Fixing these active codes should improve performance.
How to fix no GPS signal on Raven Control Systems RS1?
If no GPS information is being detected in the RS1 system, check the GPS connection and settings to resolve the issue.
What to do if the wheel angle sensor (WAS) is out of range on Raven RS1/HDU Control Systems?
If the wheel angle sensor (WAS) is out of range or disconnected, reconnect or adjust the wheel angle sensor.
What to do if SC1/TC1 system cannot be enabled on Raven RS1/HDU?
The SC1/TC1 system cannot be enabled because the SC1/TC1 disengage sensor is active. Address the active disengage sensor.
What to do if GPS signals are not converged on Raven RS1/HDU Control Systems?
If GPS signals are not converged, or GPS is converged and a warning DTC is present, address the warning DTCs or wait for GPS convergence.
How to enable SC1/TC1 system on Raven Control Systems?
The SC1/TC1 system cannot be enabled until the master switch is toggled to “field mode” because the master switch is set to “road mode.” Toggle the master switch to “field mode.”
General| Brand | Raven |
|---|---|
| Model | RS1/HDU |
| Category | Control Systems |
| Language | English |
