Raven DCS 410 User Manual

DCS 410
Installation & Service Manual
P/N 016-0159-826 Rev A 09/15
Copyright 2009, 2015

Raven DCS 410 Specifications

General

Category	Control Systems
GPS Compatibility	Yes
Data Logging	Yes
ISOBUS Compatibility	Yes
Number of Boom Sections	Up to 16
Input Voltage	12 VDC
Communication Protocol	CAN
Manufacturer	Raven Industries

Summary

Introduction to the DCS 410 System

Installation Procedures

Installing the Raven Radar

Guidelines for proper mounting and connection of the Radar unit to the vehicle frame.

Mounting Flow Meter and Control Valve

Mounting Console and Cabling

Console Features and Operation

Console Programming

Initial Console Programming Steps

Detailed steps for initial console programming, including setting US/SI, sensor type, and valve type.

Calibration Data Entry

Console Calibration

Calculating Offsets

Calculating Speed Calibration (SPEED CAL)

Steps to calibrate the speed sensor by matching console speed to vehicle speedometer.

Appendix 1: Speed Sensor Calibration

Calculating "SPEED CAL"

Detailed procedure to calculate and enter the SPEED CAL value for accurate speed readings.

Appendix 2: Valve Calibration

Calculating "VALVE CAL"

Procedure to refine valve calibration numbers based on valve type and manufacturer.

Appendix 3: Entering Offset Values

Entering Anti-Ice High Offset

Entering Anti-Ice Low Offset

Appendix 7: Flow Meter Recalibration

Procedure to Re-Calibrate Flow Meter

Steps for re-calibrating the flow meter using specific METER CAL and volume inputs.