20
DATA MENU
DEFINITION OF DATA MENU KEYS:
Depressing this key displays the selected Data Menu category in the
LIQ display.
Depressing this key again increments through the Data Menu categories
("SPr", "GPS", "dAtE", etc...) in the LIQ display.
Depressing this key (after desired category is shown in LIQ display)
advances up through desired features within a category. Selected feature
is shown in the left DATA display.
Depressing this key (after desired category is shown in LIQ display)
advances down through desired features within a category. Selected
feature is shown in the left DATA display.
SERIAL PORT SCREENS
CONSOLE DATA PRINTOUT
a) LIQ display will show "SPr". Left DATA display will show "Prn". Right
DATA display will show "CAL". To print calibration numbers, depress
.
b) Depress
to advance to print begin. LIQ display will show "SPr".
left DATA display will show "Prn". Right DATA display will show "bEGn".
To print beginning totals, depress
.
c) Depress
to advance to print end. LIQ display will show "SPr".
left DATA display will show "Prn". Right DATA display will show "End".
To print ending totals, depress
. While "End" is in the right
DATA display; if a beginning total or calibration numbers printout is
required, depress
to advance the right DATA display to "bEGn" or
CAL".
NOTE: If "End" is printed and a CAL number has been changed, a warning will
be printed (print CAL to see which number has changed).
d) Depress to advance to TRUCK NUMBER.
To Next Page
Loading...
