30
APPENDIX 3
ENTERING OFFSET VALUES
To enter known or previously obtained offsets without engaging the hydraulic system
of the vehicle the operator must perform the following procedure.
NOTE: When setting offsets the MASTER switch must be ON, and the RATE knob
must be on "M".
1) ANTI-ICE HIGH OFFSET
a) Depress until LIQ display shows "oFS". Left DATA display will show
"Anhi". Right DATA display will show "254".
b) Depressing
allows the user to use the and keys to
set to offset value desired.
c) After desired value is set, depress
. HIGH OFFSET is now set.
d) Depress
to advance to LOW OFFSET.
2) ANTI-ICE LOW OFFSET
a) LIQ display will show "oFS". Left DATA display will show "AnLo". DATA
display will show "2".
b)b)
b)b)
b)
Depressing allows the use of the and keys to set the
offset value desired.
c) After desired value is set, depress
. LOW OFFSET is now set.
d) Depress
to advance to HIGH OFFSET.
To Next Page
Loading...
