13
d) After desired offset value is set, depress . LOW OFFSET is now set.
e) Depress
to return to the ANTI-ICE HIGH OFFSET or depress any other
key to exit the offset menu.
2. CALCULATING "SPEED CAL"
1) Depress until the LIQ display shows "CAL". The left DATA display will show
"SPEd". Right DATA display will show "on" or "oFF".
2) Momentarily depress
to turn CAL speed "on".
3) Depress
.
4) While driving the vehicle at normal operating speed, depress the
and
keys to match the speed displayed in the DATA display to the speedometer
of the truck.
5) When matched, depress
and depress to turn CAL speed "oFF" when
calibrated.
6) Depress
and record value for future reference.
NOTE: This is not an exact reading. For a more accurate calibration or for radar
speed calibration refer to Appendix 1 for "CALCULATING SPEED CAL".
To Next Page
Loading...
Need help?
General
