26
e) Depress to advance to COIL FREQUENCY.
COIL FREQUENCY
a) LIQ display will show "CAL". Left DATA display will show "FrEq". Right
DATA display will show "180".
b) Enter in the frequency of the PWM valve (16 hz to 4000 hz). As specified
by the manufacture of the Hydraulic Valve. Refer to Appendix 2 for
recommended values for different coil types.
c) Depress
to advance to CAL SPEED.
d) Depress
to advance to LANE SCREENS.
LANE SCREENS
LANE WIDTH
a) LIQ display will show "LAnE". Left DATA display will show "LAnE". Right
DATA dispaly will show "12".
b) Enter the lane width (feet)[m] if desired application rate is gal/lane mile
or lit/lane km. If desired application rate is gal/mile or lit/km enter
"0".
c) If a lane width was entered depress
to advance to LEFT LANE WIDTH.
LEFT LANE WIDTH
a) LIQ display will show "LAnE". Left DATA display will show "LEFt". DATA
display will show "144".
b) Enter the left lane width (inches)[cm].
c) Depress
to advance to CENTER LANE WIDTH.
CENTER LANE WIDTH
a) LIQ display will show "LAnE". Left DATA display will show "Cntr". Right
DATA display will show "144".
b) Enter the center lane width (inches)[cm].
c) Depress
to advance to RIGHT LANE WIDTH.
RIGHT LANE WIDTH
a) LIQ display will show "LAnE". Left DATA display will show "rGht". Right
DATA display will show "144".
b) Enter the right lane width (inches)[cm].
To Next Page
Loading...
