10
1. INITIAL CONSOLE PROGRAMMING
Verify MASTER switch is OFF. After all installation procedures have been
completed, turn POWER switch to on, the Console will flash "CAL" in the LIQ
and DATA displays. This means that the Console must be "programed" before it
can be operated. This is a one-time operation which does not have to be
repeated. Turning OFF the POWER Switch or disconnecting power to the Console
does not affect the Console memory. All data is retained in nonvolatile
memory.
NOTE: The KEY switch must be in and turned to the horizontal position to enter
data into the Console. This is referred to as the "programming mode".
Only the following keys are an exception:
. A
"0" (zero) may be entered for "day distance" and "day volume". Refer to
'Distance and Volume Displays' on page 17 for procedure.
The following steps must be followed for proper calibration:
1) Selecting US (lbs/mile), or SI (Kg/km).
a) To select US or SI, depress
until the desired selection is
displayed in the DATA display.
b) Momentarily depress , the DATA display will now display SP1.
2) Selecting SP1 (drive shaft, wheel drive, etc.), SP2 (radar), or SP3
(transmission).
a) To select SP1, SP2, or SP3 depress
until desired selection is
displayed.
b) Momentarily depress
, the DATA display will now display C-P.
3) Selecting Control Valve type C-P (pulse width modulated) C-Sd (standard), C-F
(fast), or C-FC (fast close).
a) To select C-P, C-Sd, C-F, or C-FC depress
until desired code is
displayed.
b) Momentarily depress
, the DATA display will now display "0".
To Next Page
Loading...
