Raven DCS 410 - Page 24

21
TRUCK NUMBER
a) LIQ display will show "SPrt". Right DATA display will show "0".
The truck number can be entered in as 8 digits or less.
b) Enter the truck number.
c) Depress
to advance to BAUD RATE.
BAUD RATE
a) LIQ display will show "SPr". Left DATA display will show "bAUd". Right
DATA display will show "1200".
b) Depressing
steps the DATA display between "1200" and "9600".
c) Depress
to advance to RATE CHANGE ALARM.
RATE CHANGE ALARM
a) LIQ display will show "SPr". Left DATA display will show "rAtE". Right
DATA display will show "on".
b) Depressing
steps the right DATA display between "on" and "oFF". A
value of "on" means alarm is enabled; a value of "oFF" means alarm is
disabled.
c) Depress
to advance to DATA LOGGER TRIGGER VAlUES.
DATA LOGGER TRIGGER VALUE
a) LIQ display will show "SPr". Left DATA display will show "triG". Right
DATA display will show "0".
b) Enter the TRIGGER VALUE.
c) Depress
to advance to DATA LOGGER TRIGGER UNITS.
IMPORTANT : The TRIGGER VALUE default value is "0". This value must be changed
to a desired number ranging from 1-9999. The DATA LOGGER features will
not work if this number is "0".
DATA LOGGER TRIGGER UNITS
a) LIQ display will show "SPr". Left DATA display will show "Unit". Right
DATA display will show "Ft"["MEtr"].
b) Depressing
steps the right DATA display between "Ft"["MEtr"] and
"SEC". A value of "Ft"["MEtr"] means feet [meters], or a value of "SEC"
means seconds have been chosen as the unit of measurement for the TRIGGER
VALUE programmed previously.