7
7. When the XP desktop is displayed on the Viper Pro field computer, select the
“Start” button in the lower, left corner of the display and touch the “My
Computer” icon in the displayed menu.
8. Select the “Removable Disk (E:)” icon displayed on the screen with a “double
tap” to display the disk contents.
9. Double click on the “ViperST10 Programmer.exe” icon to begin the update
process. The update may take approximately 15 seconds to begin. When the
update is in progress, the Viper Pro will display a Tx and Rx window on the
screen.
Note: If the update is proceeding very slowly, shut down the Viper Pro and restart
the procedure. If the Viper Pro will not shut down, remove the main
connector from the back of the field computer for at least 10 seconds and
then reconnect.
To Next Page
Loading...
