Copyright © 2000 Rayco - All Rights Reserved
Printed in U.S.A.
19
RAYCO
®
RG 1635A STUMP CUTTER
OPERATION
Starting with Jumper Cables
NOTICE
This machine has a 12 volt starting system. Use only equal voltage for jump starting. Use of welder or
higher voltage will damage electrical system.
When starting from another machine, make sure the machines do not touch each other. This can prevent
damage to engine bearings and electrical circuits.
1. On stalled machine, turn the start switch to OFF.
2. Move boost machine near enough to stalled machine for cables to reach, but DO NOT ALLOW MACHINES
TO TOUCH.
3. Stop the engine on the boost machine.
4. Open the battery covers of both machines to purge flammable fumes.
(Continued on following page)
To Next Page
Loading...
Need help?
General
