Rayco RG 1635A - Periodic Maintenance (After 50 Hours); Hydraulic Oil Filter Change; Engine Mountings Check; Engine Belt Drives Check and Adjust

Copyright © 2000 Rayco - All Rights Reserved
Printed in U.S.A.
37
RAYCO
®
RG 1635A STUMP CUTTER
Every 50 Service Hours
Pivot Head Lower Pivot
Housing - Lubricate
Lubricate the remote grease fitting for the cutting
boom pivot head lower pivot housing. (Located below
the deck on the bottom of the pivot head.)
Pivot Head Lift Cylinder -
Lubricate Pivots
Lubricate grease fitting for cylinder rod pivots.
MAINTENANCE INTERVALS
After First 50 Service
Hours
Hydraulic Oil Filter -
Change
Change the hydraulic oil filter as described in the
•Every 250 Service Hours or 1 Year• interval, in
this •Maintenance Intervals• section.
Engine Mountings - Check
Ensure that the torque values remain as shown in
the Wisconsin [Engine] Operation Manual.
Engine Belt Drives - Check
and Adjust
Hydraulic Cylinders Pump V-Belt
Follow the directions found in the •Every 500
Service Hours or 1 Year• section.
LUBRICATE
LUBRICATE