Copyright © 2000 Rayco - All Rights Reserved
Printed in U.S.A.
RG 1635A STUMP CUTTER
RAYCO
®
24
OPERATION
• To move entire end of machine sideways, stop the
cutting wheel, move it to the side in the direction of
destination, and lower it into the ground to raise one
tire slightly. Then, using cutting wheel swing lever,
pull machine sideways, dragging the other tire.
(This maneuver should be used only where
conditions allow.)
• In colder weather the machine may be sluggish at
first. Operating all machine controls, one at a time,
will cause the hydraulic oil to warm up quickly.
Operate machine lightly until hydraulic oil is warm.
•
To Next Page
