Raymarine C-Series Reference Manual

92 C-Series Display Reference Manual
Important: Any offset entered will be applied to all charts on the chart card. You
should therefore ensure that this feature is switched off once you have transitioned off
of the errant chart. Any charting errors that you discover should be reported to
Navionics (see
page 201 ).
To switch on chart offset:
Note: If your vessel position is not available, the current chart centre is used as the ref-
erence point.
Changing the offset value
To change the offset value:
1. Select the Chart Offset function (see previous section)
2. Set the north/south offset value:
3. Set the east/west offset value:
Resetting the offset value
To reset the chart offset to zero:
1. Select the Chart Offset function (see previous section).
2. Reset to zero:
D7187-3
Alarm Setup Menu
Object Information Points ON
Vector Length Infinite
Datum WGS 1984
C
hart Offset..
.
Select Chart Offset
Toggle to ON
OFFSET
O
N
D7188_3
SET OFFSET...
ADJUST N-S
0ft
ADJUST N-S
-80ft
Adjust North/
South level as
required.
or:
D8384_1
ADJUST E-W
0ft
ADJUST E-W
121ft
Adjust East/ West
level as required.
OK
Press
Or
or:
81221_4.book Page 92 Tuesday, February 28, 2006 5:24 PM

Raymarine C-Series Specifications

General

Brand	Raymarine
Model	C-Series
Category	GPS
Language	English