Chapter 3: Installation 27
The cable connections are located on the back of the display unit. All cables can be
connected prior to mounting the unit on the trunnion bracket. Please read the details
relating to each cable before connecting them.
Note:
For details of what is connected to each of these cables please refer to the diagrams on
page 15, page 17 and page 18.
How do I use the cable splicers?
The cable splicers are used to make the connections from the SeaTalk/Alarm out and
NMEA 0183 cables easy and secure, without removing insulation from cable tails.
Note:
Do not use cable splicers on any cables other than SeaTalk/Alarm out and NMEA 0183.
To use these connectors:
1. Place the wires to be joined into the connectors, ensuring correct polarity and that
the wires are pushed fully home.
D7210-1
VGA out
SeaTalk
HS
Supplied
Not supplied/accessory
Radar
Power
NMEA
0183
SeaTalk/
Alarm out
SeaTalk
2
Video in
E-Series cable connections
To Next Page
Loading...
