4
Notes:
1. Each keyboard and base station communicate as a dedi-
cated pair.
2. You should have at least one permanently wired keyboard.
In the event that any wireless keyboards are lost, the wired
keyboard can be used to control the system.
3. When connecting a keyboard to the system, record its details
on your system diagram. You will need this information
during commissioning. (Refer to the separate G-Series
system installation instructions for sample diagrams.)
Wireless keyboard & base station cables
Charge keyboard
Charge for 6 hours
Before proceeding with the installation you must charge the
keyboard. If the SeaTalk
ng
wiring is not installed, you will need to
create a temporary keyboard connection with power as shown.
See also
• For information on the keyboard battery and charge point. Refer
to separate instructions supplied with the wireless upgrade kit.
Cable Part No Notes
Wireless base station to SeaTalk
ng
1 m (3.3 ft)
SeaTalk
ng
spur cable (bare ends)
A06043 Included with wireless base
station.
3 m (9.8 ft)
SeaTalk
ng
spur cable (bare ends)
A06044
Keyboard charging
2.5 m (8.2 ft)
charging cable
R08311 Included with the wireless
upgrade kit.
3 m (9.8 ft)
SeaTalk
ng
bulkhead mounting
cable
R08310
SeaTalk
ng
power
12 Vdc to SeaTalk
ng
A06049
12 V dc,
5 A fuse supply
D10688-1
G-Series Keyboard rear
SeaTalk
ng
power cable
SeaTalk
ng
spur
SeaTalk
ng
backbone
87086_1.book Page 4 Thursday, October 4, 2007 8:47 AM
To Next Page
Loading...
