Raymarine Raynav 300 GPS Plotter - 5.5 Connecting to Other Equipment; Connecting to Other Equipment

To Next Page

To Previous Page

5-10 Raynav 300 GPS Plotter

12. Screw the studs into the vacant holes at the rear of the unit, hand tight

only.

13. Slide a spacer ferrule onto each stud.

14. Secure the unit with the thumb nuts, hand tight only.

Figure 5-5: Panel Mounting

5.5 Connecting to Other Equipment

The unit transmits navigation and waypoint data on NMEA

and SeaTalk

and, therefore, can be connected to an NMEA compatible autopilot or

instrument repeater(s). The navigation data transmitted and received by

the Plotter is detailed in Appendix B to this handbook.

1.National Marine Electronics Association (NMEA) 0183 interconnection stan-

dard, Version 2.3 April 1998.

D4969-2