Chapter 3: Operation 3-43
Note: Track points are not ‘wasted’ when the vessel is stationary as there
is a minimum distance separation, even when using a time interval set-
ting.
➤ To set up a track:
1. From the plotter display, press the MENU key to display the set up soft
keys as shown in Figure 3-42.
Figure 3-42: Set Up Soft Keys
2. Press the TRACK SETUP soft key to display the first level Track soft
keys as shown in Figure 3-43:
Figure 3-43: First Level Track Soft Keys
3. Press the MORE... soft key to display the second level Track soft keys
as shown in Figure 3-44.
Figure 3-44: Second Level Track Soft Keys
4. Press the appropriate TRACK INTERVAL up/down soft key to set an
appropriate TIME or DISTANCE interval.
5. Press MORE to return to the first level Track soft keys.
6. Press the TRACK OFF ON soft key to toggle tracks on/off.
Your vessel’s trail will be displayed on-screen, with a line joining the
points at the selected interval.
7. To return to the default soft key display, press CLEAR.
Clearing the Current Track
You can clear the current track from the screen. When you select CLEAR
TRACK, if the current track has not been saved, you have the option of
saving it.
➤ To clear the current track:
1. Press the CLEAR TRACK soft key.
2. If the track has not been saved, the SAVE TRACK soft keys are dis-
played.
SYSTEM
SET UP¬
CHART
SET UP¬
TRACK
SET UP¬
GPS
SET UP¬
D4918-1
CLEAR
TRACK
MAKE INTO
ROUTE
MORE…
TRACK
OFF ON
D4919_1
TRACK
LIST
MORE¬
TRACK INTERVAL
1S
D4920-1
To Next Page
Loading...
General