Chapter 8: Installation 8-17
Connecting the
Inter-unit Cable to
the Scanner
CAUTION:
It is essential that the drain tube is fitted and that the nut on the
watertight gland is adequately tightened. If this is not done, water could
become trapped in the scanner and cause irreparable damage.
11. Tighten the securing nut (1) again to ensure a waterproof seal.
12.Untie the cord from the scanner cover, and coil it up in the base of the
scanner unit so that it cannot foul the rotating antenna.
13.Replace the scanner cover, aligning the mark on the cover with the mark on
the scanner base above the cable gland, and tighten the 4 captive screws.
Do not over-tighten these screws.
To Next Page
Loading...
