EasyManua.ls Logo

Raymarine SL72 - 8.8 Mounting the Display Unit; Mounting Bracket

Raymarine SL72
243 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8-18 SL72 & SL72RC PLUS Pathfinder Radar & Radar/Chartplotter
Mounting the
Display Unit
8.8 Mounting the Display Unit
The SL70 and SL70RC PLUS LCD display units are waterproof to CFR46
and can be installed either above or below deck. The display unit can be
mounted using the mounting bracket supplied, or console mounted using the
optional flush-mounting kit (see Section 8.2).
Mounting Bracket
The display unit can be mounted on a dash, chart table, bulkhead or deckhead.
Figure 8-10: LCD Display Mounting
1. Loosen the knobs and remove the mounting bracket from the display unit.
2. Mark the locations of the mounting bracket screw holes on the mounting
surface.
3. Use the screws supplied to attach the mounting bracket at the marked loca-
tions.
4. Attach the display unit to the mounting bracket, adjust the display angle
and tighten the knobs.
Console Mounting
The display unit can be console mounted if required, using the optional flush-
mounting kit (M92708).

Table of Contents

Related product manuals