Raymarine ST40 - Page 42

Chapter 4: Calibration
33
DEALER CALIBRATION
BIDATA
CAL
CAL
BIDATAST40
CAL
CAUTION:
Do NOT switch the Boat Show mode on.
This function must only be used for
demonstration purposes.
ST40
BIDATAST40
BIDATAST40
Entry
screen
D4746-2
for approximately 12 secondshold down and
Calibration
access
Boat show
mode
Factory
defaults
for approximately 2 seconds
hold down
and
If
If
Return to
normal
operation
with factory
defaults set
During normal operation
To save your settings and return to normal operation from any screen,
Note:
If there is no key activity when the Entry screen
is displayed, calibration will time out to normal
operation after 5 seconds,
159_2c04.p65 01/05/01, 15:1533