Raymarine ST40 - 4.4 Dealer calibration

32 ST40 Bidata Instrument Owner’s Handbook
INTERMEDIATE CALIBRATION
BIDATA
CAL
CAL
ST40
BIDATA
ST40
BIDATA
ST40
Note:
If there is no key activity when
the Software version screen
is displayed, calibration will
time out to normal operation
after 5 seconds,
Software
version
D4745-2
for approximately 4 secondshold down and
Depth
status
To save your settings and return to normal operation from any screen,
Speed
status
During normal operation
for approximately 2 secondsand
hold down
4.4 Dealer calibration
Dealer calibration enables you to set:
• User calibration on/off.
• Boat show mode on/off.
Dealer calibration also gives access to the Factory defaults screen.
This enables you to reapply the factory settings if you want to reset the
instrument to a known operating condition.
Follow the procedure in the Dealer calibration flow diagram.
159_2c04.p65 01/05/01, 15:1532