Autohelm
AutohelmAutohelm
Autohelm
SeaTalk Service Manual
4
5. Pull the loom assemblies back through the grommets when lowering the cover to
ensure that the cables do not bunch up inside the cover and foul the PCB on re-
assembly.
6. Refit the cover.
7. Re-check for full function after re-assembly to check the LCD has not been
damaged or looms incorrectly soldered. Adjust LCD contrast if necessary.
4. Display Contrast adjustment
The LCD Contrast can be adjusted to suit a wide range of control unit viewing angles.
Push display and track together momentarily.
Push response ▲ to increase contrast (suits viewing from below).
Push response ▼ to decrease contrast (suits viewing from above).
Adjust the display for optimum viewing.
Push display and track together momentarily to store selection and return to previous
operating mode.
To Next Page
Loading...
