ST80 Active Speed & Depth Transducer Installation
4
1.2 Installing the Depth Sensor
Procedures for fitting the sensor to the hull of your vessel are
supplied in the sensor package. Please read these instructions
thoroughly before attempting to install the unit.
General Points to remember
A warning label covers the face of the depth sensor. This label
should be removed before use and the face of the sensor “wetted”
with a household detergent.
The sensor should be installed so that it is:
• near the centreline of the vessel (within 10° of the vertical)
10 Max
D630
• ahead of the propellers and forward of the keel
• clear of all other through hull fittings or projections
To Next Page
Loading...
