ST80 Active Speed & Depth Transducer Installation
5
1.3 Installation of the Data Processing Unit
The cables from the data processor are 2m (6ft) in length. Therefore,
a 3-way SeaTalk connector block must be sited within 4m (12ft) of
the transducer.
Use the 19mm (3/4in) self-tapping screws to mount the processor
vertically or horizontally to a springer or beam.
D2345-1
Note: Position both the data processor and the SeaTalk connector block
clear of any bilge water.
1.4 Connection to SeaTalk
Plug the free end of the data processor cable into any 3-way
connector block.
D2344-1
To Next Page
Loading...
