Raymarine T150 - PCB Details and Component Identification; Course Computer Inputs and Outputs

T150/150G/T400/400G Course Computers
32 Type 150/150G/400/400G Course Computers Service Manual 83156-1
Type 150/400 Course Computers
Chapter 6: PCB Details
6.1. Inputs and outputs
D5720-1
Spare connectors
for future upgrades
(Type 400 only)
Fluxgate
compass
inputs
External
GyroPlus
yaw sensor
inputs
Rudder
position
sensor inputs
SeaTalk
inputs/
outputs
Power inputs
Type 150: 12 V
Type 400:
12 V or 24 V
Drive solenoid
return inputs
(for drives/pumps
with solenoids)
NMEA 0183
inputs/outputs
Off switch
inputs
Drive
motor
outputs
Drive clutch
outputs
Type 400:
selectable for
12 V or 24 V
Terminal blocks
1291013144171615 8 12 5 6 3 7 11
Terminal
block
Color/label Signal Direction
1 POWER + Nominal +12 V or +24 V DC IN
POWER – 0 V IN
2 OFF SWITCH Switch contact 1 IN
OFF SWITCH Switch contact 2 IN
3 MOTOR A Motor A OUT
MOTOR B Motor B OUT
4 FLUXGATE gray Compass drive 2 OUT
FLUXGATE red VRESET OUT
FLUXGATE green Compass output F/GA IN
FLUXGATE yellow Compass output F/GB IN
FLUXGATE blue Compass drive 1 OUT
5 NMEA 1 + NMEA 1 In + IN
NMEA 1 – NMEA 1 In – IN
6 NMEA 1 + NMEA 1 Out + OUT
NMEA 1 – NMEA 1 Out – OUT
7 SOLENOID – Ground return 1 IN
SOLENOID – Ground return 2 IN
8 RATE GYRO red Nominal +12 V DC IN
RATE GYRO gray 0 V IN
RATE GYRO yellow Gyro Signal 0-5 V IN
9 SeaTalk gray 0 V OUT
SeaTalk red +12 V OUT
SeaTalk yellow SeaTalk data IN/OUT
10 SeaTalk gray 0 V OUT
SeaTalk red +12 V OUT
SeaTalk yellow SeaTalk data IN/OUT
11 CLUTCH – Clutch – OUT
CLUTCH + Clutch + OUT
12 RUDDER gray 0 V IN
RUDDER red +5 V IN
RUDDER green 0 V IN