Temp: XXX ( XXX ) m :x
XXX%XXX%XXX%XXX%XXX%
tandard
Initialize
LEAD LAG, NIGHT SET BACK
Initialize
Y - Yes
N - No
Version # of software.
* This will initialize all previous selectable values to default values. Should not be
used unless operator wants to reprogram new values. Should be used at Start-up
to clear the control memory.
This should be by-passed, if controls have been initialized as the first step.
Standard
Utility Service LEAD LAG, NIGHT SET BACK
Utility Service
Displays controller operating mode,
changes continously from 1 to 5.
Displays Firing Rate of each Boiler Displays System Target Temperature
Displays Actual System Temperature
Information Only.
Displays the system operating conditions and the firing rate of each boiler up to total of (5).
Page 35
VX . XXXX I ni t i al i z e?
Y
To Next Page
Loading...
