Raypak 013464F User Manual

Page 1
RAYPAK REPLACEMENT INSTRUCTIONS
PC BOARD & TEMPERATURE CONTROL (KIT #013464F)
FOR GAS POOL HEATERS WITH ELECTRONIC IGNITION (SEE “SCOPE” FOR MODELS)
IMPORTANT NOTICE
These instructions are intended for use by qualified personnel specifically trained and experienced in the installation of this
type of heating equipment and related system components. Installation and service personnel may be required to be li-
censed in some states. Installation or repairs performed by unqualified persons may void the warranty.
DANGER - SHOCK HAZARD
Make sure electrical power to the heater is disconnected to avoid potential serious injury or damage to components.
DANGER - PROPANE HAZARD
Make sure to determine if unit is propane and see special instructions on page 6.
SCOPE:
This version of the temperature control board has an integrated ignition module plus 3-wire temperature sensor. It is a di-
rect replacement for the following models: 185B, 206A, 207A, 265B, 266A, 267A, 268, 335B, 336A, 337A, 405B, 406A,
407A, 408.
P/N
241417Rev 4
Effective: 12-04-12
Replaces: 10-07-11
MODELS
185B, 265B, 335B, 405B
PRODUCED NOV. 2003
THROUGH OCT. 2004
SERIAL # 0311 TO # 0410
MODELS
206A, 266A, 336A, 406A
207A, 267A, 337A, 407A
268, 408
PRODUCED NOV. 2004
THROUGH CURRENT
SERIAL # 0411 TO CURRENT
This Kit Includes:
(1) PC Control Board
(1) LCD Gasket
(5) Screws #6 x 3/8”
(1) Remote Mode Label
(1) Instructions

Raypak 013464F Specifications

General

Model	013464F
Power Supply	24 VAC
Display	Digital
Brand	Raypak
Type	Controller
Compatibility	Raypak Pool Heaters
Application	Pool and Spa Heating
Voltage	24 VAC

Summary

PC BOARD & TEMPERATURE CONTROL KIT

SCOPE

Identifies specific Raypak heater models compatible with the kit.

ACCESSING THE CONTROL BOARD

REMOVING THE CIRCUIT BOARD

PROPANE HEATERS ONLY: PREPARE NEW REPLACEMENT CONTROL PCB FOR INSTALLATION

MODELS 185B, 265B, 335B & 405B, Lo NOx ONLY: PREPARE NEW REPLACEMENT CONTROL PCB FOR INSTALLATION

Lo NOx MODELS 207A, 267A, 337A & 407A ONLY: PREPARE NEW REPLACEMENT CONTROL PCB FOR INSTALLATION

GASKET INSTALLATION - ALL MODELS

REPLACEMENT CONTROL BOARD - ALL MODELS

INSTALLING THE SAFETY AND GAS VALVE HARNESS ONTO P2 AND P4

Instructions for correctly connecting the safety and gas valve harness.

THERMOSTAT OPERATION - ADVANCED FLAME TECHNOLOGY (AFT) BOARD

Program Button Functions

Details on accessing program screens and settings via the Program Button.

Fahrenheit or Celsius Setting

How to switch the temperature display between Fahrenheit and Celsius.

Control Lockout Feature

Explains how to use and bypass the control lockout feature with a PIN.

STATUS AND DIAGNOSTICS

REMOTE CONTROL INSTALLATION AND OPERATION

2-Wire Remote Control (On-Off)

Instructions for connecting a 2-wire remote control for basic on/off function.

3-Wire Remote Control Using Three-Position Switch

Instructions for connecting a 3-wire remote for pool/spa control.