Raytheon Beech Baron E55 - Page 378

~eechcraft
BARON
55
AND
58
SHOP
MANUAL
OIL RADIATOR REMOVAL
(Effectivity:
a.
Remove
the
12
attaching
bolts.
TC-I
and
after)
b.
Disconnect the oil
temperature
bulb.
The oil radiator is located
at
the
right
front
of
each
c.
Disconnect
the oil
drain line.
engine.
Removal
may
be
accomplished
as
follows:
d.
Remove
the
five
retaining
nuts.
a.
Remove the
baffling
around the
oil
radiator.
e.
Remove
the
radiator
and
gasket.
b. Remove the
12
mounting
bolts
at
the base
of
the
radiator.
OIL
RADIATOR
INSTALLATION
(Effectivity:
c.
Remove
the radiator and
gasket.
TE-I
and after and TH-I
and
after)
OIL RADIATOR
INSTALLATION
(Effectivity:
a´•
I"stall
a new
gasket.
TC- I
and
after)
b. Install the
radiator.
a.
Installanewgasket,
c.
Install
the five
retaining
nuts.
b. Install the radiator.
d.
Connectthe
oildrain line.
c.
Install the
12
mounting
bolts
at
the base of the
e.
Connect
the oil
temperature
bulb.
radiator
f. Install the
12
attaching
bolts.
d. Install the
baffling
around
the
oil
radiator.
OIL
PRESSURE
INDICATOR
OIL RADIATOR REMOVAL
(Effectivity:
TE-
1
and
after
and TH-I and
after)
The oil
pressure
indicator
was a
direct-reading
instru-
ment
on
TH-1
thru TH-1395
except
TH-1389. An
elec-
The oil radiator is
located
at
the left
rear
of each
eng-
tric
oil
pressure
indicator
was
installed
on
TH-1369
ine. Removal
may
be
accomplished
as
follows:
and
TH-1396
and
after. The
oil
pressure
transmitter
is
located
to
the
right
of
the
engine
centerline
and
is
attached
to
the aft side of the firewall
on
both the left
and
right
engines.
OIL
PRESSURE
TRANSMITTER
2
REMOVAL
(Effectivity:
TH-1389 and
TH-1396
and
after)
3
a.
Remove the stainless
steel heat shield from
the
bottom
of
the
engine
nacelle.
NOTE
5’
Note
the
position
of
the
electrical
wires
and label them for reinstallation.
THROTTLE
IN
TOLE POSITION
b.
Disconnect
the electrical wires from the
transmit-
ter.
i.
SWITCH
c.
Disconnect
the oil line from the
transmitter.
2.
CAM
FOLLOWER
3. CAM
d. Remove the
screw
holding
the transmitter
4.
SAFETY WIRE
clamped
to the firewall.
5.
ROLL
PIN
e.
Removethe
transmitter.
C95TH2780260
C
OIL
PRESSURE
TRANSMITTER
INSTALLATION
(Effecfivity:
TH-1389 and
TH-
1396
and
after)
a.
Place
the
transmitter
in
position
in
the
clamp
and
Figure
6-4.
Throttle
Warning
Horn
Cam
install
the
screw
in the
clamp.
515
6-5