Raytheon Beech Baron E55 - Page 690

Rnytheon
nirerart
Company
BARON
55
AND
58
SHOP MANUAL
TAIL
STROBE
LIGHT
REMOVAL
AND
INSTALLATION
CA
UTION:
To
avoid
damage
to
the strobe
light
system
or
possible
physical injury
from
electrical
shock,
observe
the
precautions
outlined
under STROBE
LIGNT
WIRING
in
this section before
removing
or
installing
the
strobe
light
assembly.
a.
Remove the
retaining
screws
securing
the
strobe
light assembly
in
place
on
the
tail
cone.
b.
Remove the
lens
retainer,
and
lens.
c.
Disconnect
the strobe
light
from
the
airplane
electrical
system
and
remove
the flashtube.
d.
Reverse the
forgoing procedures
to
reinstall
the
strobe
light assembly.
TAIL STROBE
LIGHT REMOVAL
(GRIMES
AND
SYMBOLIC DISPLA
YS
INC.)
WARNING:
High
voltage
is involved
in
the
circuit
between the
power
supply
and strobe
light
assemblies.
Turn
the
control
switch
for
the strobe
lights
OFF
and
allow
at
least
10
minutes
to
elapse
prior
to
disconnecting
the cables
at
the
power
supply
or
strobe
light
assemblies
and
before
handling
either
of
these
units
in
any way.
Failure
to
observe
these
precautions
may
result
in
physical
injury
from electrical shock.
a.
Remove
the screws
from the lens and
remove
the lens.
b.
If
the
nav
light
needs
to
be
replaced,
rotate
the
bulb counterclockwise
and
remove
the
nav
light
bulb.
c.
Remove the
tail
cone
and disconnect the
wire
connector.
d.
Remove the screws
from the
light
assembly
and
remove
the
light
assembly.
TAIL
STROBE
LIGHT
INSTALLA
TION
(GRIMES
AND
SYMBOLIC DISPLA
YS
INC.)
WARNING:
High
voltage
is involved in
the
circuit
between the
power
supply
and
strobe
light
assemblies.
Turn
the
control
switch
for the
strobe
lights
OFF and allow at least
10
minutes
to
elapse
prior
to
disconnecting
the
cables
at
the
power
supply
or
strobe
light
assemblies
and before
handling
either
of these units in
any
way.
Failure
to
observe
these
precautions
may
result
in
physical
injury
from electrical shock.
a.
Place
the
light assembly
in
position
in
the
tail
cone
and install the
screws.
b.
Make
the
electrical connection
and
install
the tail
cone
on
the
airplane.
c.
Installthe
nav
light
if
removed.
d.
Installthe
lensgasket.
NOTE:
If
there
is
a
lens drain hole be
certain the
drain is
not
obstructed.
e.
Installthe
lens.
f.
Install
the
lens
retainer and
secure
with
the
screws.
E21
SECTION
13Page
93