ASSEMBLY AND SET-UP
Need Help? Visit our website for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer
Service contact information is listed at the back of this manual.
4
Turn power switch off before conducting any assembly or maintenance procedures.
Attaching the Seat Back Cushions
Remove release paper from back of seat back cushions to expose the adhesive. Adhere seat back cushions to the seat
back as shown in the image above.
WARNING: Failure to
properly install and tighten the
screws, nuts and bolts that affix the
steering wheel and seat can cause
you to lose control and crash.
NOTE: The lap belt arrangement
supplied is not intended for use in
larger, faster vehicles and is for
“play” use only. It is not an ASTM-
approved safety belt system and
is not intended to function as an
approved lap/seat restraining device.
Attaching the Seat
Required Tool: 4 mm Allen Wrench (included)
1 Position the seat over the frame and align it with the
holes in the frame.
2 Insert the four (4) bolts and washers and tighten
securely using a 4 mm Allen wrench.
Note: Lap belt does not require assembly.
To Next Page
Loading...
Need help?
General
