UNC100 Axiom Hardware Manual V1.1 RBH Access Technologies Inc.
Page 16 of 20
Output Operation
General Purpose Output
General Purpose Outputs are outputs that are user controlled. They are activated and de-activated by
user defined links and schedules.
Lock Output
For magnetic locks, the relay should be configured from the PC as On State de-energized for fail-safe
operation. If power fails (AC and battery) the power to the magnetic lock is removed and the door is
opened.
Handicap Output
This output is used to drive door operators. It turns on in less than one second after the Lock Output is
turned on, and stays on until the Lock Output is turned off. Only designated cardholders will activate this
output.
Forced / Tamper
The Forced/Tamper output turns on if the door is forced open or if a reader tamper is detected. This
output remains on for as long as the alarm condition exists.
Modem Power Output
The Modem Power Output is a normally activated output that is used to reset a modem by momentarily
removing the power from the modem.
For ULC-S319-05 III compliance, all wiring into the panel’s cabinet must enter through metal conduit.
Also be sure to mount the panel in a protected area.
To Next Page
Loading...
Need help?
General
