RBSM Mud Adder - XX-2. Tightening torques for screw connections; XX-3. Tires and tire pressure; XXI.Warranty conditions

44
XX-2. Tightening torques for screw connections
WARNING:
Only use a suitable tool, a torque wrench for example, to tighten the screw connections
as otherwise the screws could shear off or break.
NOTE: If you tighten screws too tightly, this could damage the components You should there-
fore always observe the prescribed tightening torque.
SCREW CONNECTION THREAD TIGHTENING TORQUE (NM)
Crank arm M8x1 30
Pedal 9/16" 30
Axle nuts, front qen. 25
Axle nuts, rear gen. 30
Stem expander bolt wedge M8 23
Stem, A-head, handlebar clamping xture M5/M6/M7 M5:5/M6:10/M7:14
Stem, A-head, head tube M5/M6/M7 M5:5/M6:10/M7:14
Bar end, outer clamp M5/M6 M5:5/M6:10
Seat post, clamp M8/M6 M8:20/M6:10
Seat post, saddle clamping bracket M7/M8 M7:14/M8: 20
Front derailleur clamp M5 5
Brake, pad M6 10
Brake, cable clamp M6 10
Sidewall dynamo, xing M6 10
Disc brake calliper M6 8 to 10
Shifting lever clamp M5 5
Brake lever clamp M5 5
V-brake, fastening screw M6 10
Freewheel fastening screw n. a. 40
Cassette, lock ring n. a. 30
NOTE: These value are reference value, observe the values in the encbsed operating instruc-
tion of the component manufacture.
XX-3. Tires and tire pressure
The tires should be pumped up to within the range stated on the sidewall. This should be regu-
larly checked as running with the correct pressures will ensure maximum range from frie battery.
XXI. Warranty conditions
Read chapter "Care and maintenance of the bike careftjlly. Comply with the inspection and
maintenance intervals specied in Chapter 'Regular inspections". Compliance with the service
intervals is a prerequisite for the assertion of warranty claims.
The statutory warranty period is two years. This starts when the bike is handed over by the spe-
cialist cycle shop who is also your contact partner for warranty claims.