RCA RPJ112

13
Connecng to a computer by VGA cable
Follow below picture to connect a computer to the projector.
1. Press the buon to turn off power of your projector before connecon.
2. Aer connect, press the buon to turn on unit and power indicator will light GREEN
3. Press the buon to VGA mode and the video of VGA device will show on projector screen.
4. Press the buon to turn off unit power.
Please refer to the following table to adjust the output signal from computer
To V
Computer cable not included
GA PORT
NOTE BOOK
DECK TOP
OR
COMPUTER CABLE
COMPUTER CABLE
Type Resoluon Frequency Field Frequency
VGA 640x480 31.5 60
34.7 70
37.9 72
37.5 75
31.4 50
35.1 56
SVGA 800x600 37.9 60
46.6 70
48.1 72
46.9 75
40.3 50
XGA 1024x768 48.4 60
56.5 70
PC