GO-TO SEARCH
The Go-To Search feature enables the VCR to quicHy locate a
counter reading anywhere on the tape. When the VCR locates
the counter reading, it will begin playback.
1. Press STOR
2. Press SEARCH on the remote until the GO-TO SEARCH menu
appears on the screen.
3. Press number buttons to enter the hour and/or minute of
the counter reading you want the VCR to "go to." Press
CLEAR on the remote to correct an entry.
4. Press FORWARD to search ahead or REVERSEto search
behind.
5. Press STOPto end Go-To searching.
GO-TO SEARCH
Current tape counter is
2:17:25
Press REV or FWD
to go to -:--:00
Press SEARCH to exit.
GO-TO SEARCH
Current tape counter is
2:17:25
Press HEV or FWD
to go to 0:00:00
Press SEARCH to exit.
TRACKING
Your VCR has automatic tracking which removes interference like
streaks or "snow" from the picture. Automatic tracking is
automatically activated when you insert a tape or turn on the
VCR. Occasionally you may need to manuaUy adjust tracking,
especially if the tape was recorded on a different VCR. Just use
the TRACKING buttons to reduce the distortion. You can also use
tracking when you pause a tape to reduce jittering of the
picture.
When you manually adjust the picture, automatic tracking is
turned off. To turn automatic tracking back on, press both
TRACKING buttons on the front of the VCR at the same time, or
eject the tape and re-insert it. Tracking has no effect during
recording- only playback.
I If you insert a pre-recorded tape 1
with the safety tab removed-- Index
and Go-To searches are not available.
47
To Next Page
Loading...
