8
ENGLISH
INSTALLATION
Ensure to install the loudspeaker safety, verifying that the fixing surface is
resistant and solid enough to support the loudspeaker weight, in order to
prevent risks of falling that could put the safety of people and structures in
jeopardy.
Do not tighten the screws to fix the loudspeaker too much, to avoid
damaging the M6 threaded inserts.
The accessory is installed as follows (see the picture):
1. Using 2 plugs (not provided) to fix the support at the chosen point
on the wall. The plugs to be used must be chosen carefully depending
on the type of wall (plasterboard, hollow bricks, solid bricks, concrete,
panels, etc.).
2. Fix the loudspeaker to the support, screwing the two P knobs into the
M6 threaded inserts of the loudspeaker, but without tighten them.
3. Adjust the aiming angle and then tighten the P knobs
P
P
CONNECTIONS
iN order to preveNt the risk of electric shock, eNsure the amplifier is switched off
(before coNNectiNg the loudspeaker).
Notes:
- To ensure a correct musical reproduction, loudspeaker phase is to be
respected (loudspeakers are connected respecting the amplifier polarity).
This is important when loudspeakers are installed adjacent one another,
for instance, in the same room. Use bipolar cables that have markings to
distinguish the polarity (e.g. insulation of different colours, conductors of
different colours, etc.).
- To prevent inductive effects from causing hum, noise and a bad system
working, loudspeaker lines should not be laid together with other electric
cables (mains), microphone or line level signal cables connected to amplifier
inputs.
- The loudspeaker cable shall have wires with a suitable section (twisted, if
possible, to reduce inductive effects due to surrounding electro-magnetic
fields) and a sufficient electrical insulation. The greater the distance between
the amplifier and the speaker, the larger the connection cable cross-section
should be to limit the voltage loss along the line.
To Next Page
Loading...
Need help?
General
