10
10. If the amplifier begins to emit any strange odours or smoke, switch it off immediately and disconnect the power supply cable.
11. Do not connect this product to any equipment or accessories not specified. For suspended installation, only use the
dedicated anchoring points and do not try to hang this product using HANDLES or elements that are unsuitable or
not specific for this purpose. Also check the suitability of the support surface to which the product is anchored (wall,
ceiling, structure, etc.), and the components used for attachment (screw anchors, screws, brackets not supplied by
RCF etc.), which must guarantee the security of the system/installation over time, also considering, for example, the
mechanical vibrations normally generated by the transducer. To prevent the risk of falling equipment, do not stack
multiple units of this product unless this possibility is specified in the instruction manual.
12. RCF Spa. strongly recommends this product is installed by professional qualified installers (or specialised firms)
who can ensure correct installation and certify it according to the regulations in force. The entire audio system must
comply with the current standards and regulations regarding electrical systems.
13. Supports and trolleys. The equipment should only be used on trolleys or supports, where necessary, that are recom-
mended by the manufacturer. The equipment/support/trolley assembly must be moved with extreme caution. Sudden
stops, excessive pushing force and uneven floors may cause the assembly to overturn.
14. Hearing loss. Exposure to high sound levels can cause permanent hearing loss. The acoustic pressure level that leads
to hearing loss is different from person to person and depends on the duration of exposure. To prevent potentially
dangerous exposure to high levels of acoustic pressure, anyone who is exposed to these levels should use adequate
protection devices. When a transducer capable of producing high sound levels is being used, it is therefore necessary
to wear ear plugs or protective earphones. See the technical specifications in the instruction manual for the maxi-
mum sound pressure the loudspeaker is capable of producing.
IMPORTANT NOTE
To prevent the occurrence of noise on the cables that carry microphone signals or line signals (for example, 0 dB), only
use screened cables and avoid running them in the vicinity of:
• equipment that produces high-intensity electromagnetic fields (for example, high power transformers);
• mains cables;
• lines that supply loudspeakers.
GENERAL OPERATING PRECAUTIONS
• Do not obstruct the ventilation grilles of the unit. Situate this product far from any heat sources and always ensure
adequate air circulation around the ventilation grilles.
• Do not overload this product for extended periods of time.
• Never force the control elements (keys, knobs, etc. ).
• Do not use solvents, alcohol, benzene or other volatile substances for cleaning the external parts of this product.
To Next Page
Loading...
Need help?
General
