Z-Wave® Operation
If the thermostat is installed in a network while running on batteries, it will be enrolled on
to the ADT Pulse
®
network and not a pass through and repeater. This is a power saving
mode that conserves the batteries by keeping the radio asleep most of the time. However,
in this mode, the thermostat does not act as a repeater in the Z-Wave network.
If the THERMOSTAT is installed in a network while powered by 24VAC, it will be enrolled
as an always-listening device and can act as a router node in the Z-Wave network.
Caution! Once installed in a Z-Wave network, if you change how the thermostat is
powered (from batteries to 24VAC or vice versa), you must remove and re-enrolled
the thermostat in the Z-Wave network for it to work correctly.
Adding the Battery-Powered Thermostat Model TBZ48 to your ADT
Pulse
®
Wireless Network
Open your web browser. In the address bar, type: https://Portal.ADTPulse.com.
Type your Username and Password then click the Sign In button.
DCN: 140-02121-06 Page 19
To Next Page
Loading...
