DCN: 141-01773-02 1/19/11
12
Main Menu
The Menu button on the main Thermostat Control Screen selects the MAIN MENU screen. The Main
Menu is a list of the primary thermostat setting screens. Selecting these items will take you to additional
submenu screens for specific settings.
Main Menu Selections
Note. Some menu items are optional. They must be enabled in the Installer Settings menu during
the system setup to show up in the Main Menu list.
Schedules. (Optional). This screen is used to view and set the programmable setback schedules of the
thermostat.
User Settings. This screen is used to set the Clock, Filter Service, Maintenance Service, Screen
Timeout, F/C mode, Sensor Calibration and Backlite/Display settings.
Usage Graph. Shows daily heating and cooling run time hours for a week.
Away Setpoints. Sets the energy savings Away setback heating and cooling setpoints.
ZWave Install. Used to install the thermostat into a ZWave network.
Thermostat Info Screen: This screen shows the firmware versions of the Thermostat and the Zwave
interface, ZWave network IDs, and the HVAC system type setup.
To Next Page
Loading...
Need help?
General
